Door and Boot Sponge

1/2 " dia sponge filler Sold as: Meter

SOLD PER FULL MTR. Universal seal  for TRUCKS AND CARS. Fix to door with our 3M adhesive. SIZES base is 10mmx 11mm leg is 18mm in total.

 Door seal hard rubber,slides into channel on doors. Sold by the MTR.

SOLD PER MTR This item glues to the boot lid or may be a door post hinge side upright seal. SIZES Width 25mm  height 12mm will  Crush to 9mm Use our 3M adhesive for this job.

 Glue direct to the boot lid. or into body track . 18.5mm wide and 14mm height will crush to 9mm. Glue with our 3M products.

 Boot seal for Austin  and other English Vehicles Fits into channel on body work. MATERIAL is 6MM wide x 11mm deep at channel. Total height of 20mm  SOLD PRE METER

SOLD PER MTR. Glues to boot gutter. SIZES  width of base 12mm body flap extends 6mm Uncrushed height 20mm will crush to 16mm For best results use our 3M adhesive for this job. Join end to end with super Glue...

  SOLD PER Full MTR. Solid sponge. closed cell does NOT hold water Size 6.2 x 13.5 approx. glue on with our 3M weather strip adhesive.

D sponge with self adhesive tape. 17mmx15mm Sold as: Meter

D sponge with self adhesive tape. 15mmx 10mm Sold as: Meter

Door & Boot sponge HOLDEN FX-J fits channel 12mm wide and 9mm deep height  open 18mm Sold as: Meter

The ADHESIVE for door and boot rubbers.  Tube contains 147mls.  Black in colour

SOLD PER MTR. Glues into the corner of door frame with our 3M adhesive for best results. Join end to end with super glue. SIZES.  base width 16mm  Height of main seal is 18mm. Lower secondary seal is...

SOLD PER MTR. Glues to door frame wide edge as the base, may be reversed to suit your job. SIZES base width 13mm   Height 11mm. Glue on with our 3M adhesive.

 Chevrolet Buick Pontiac Check your old Sample to this. Base size 17mm  height 13.25mm Hollow section to allow compression. Best glued with our 3M products. Sold pr mtr.

Fits on body later  Austin A40. This is an extra seal to help keep out the Aussie DUST Fitted after Herbert Austin visited Australia. Sold by the Metre.

Aussie made for Pommie cars good Stuff. Can be joined to itself with our Super glue for positive joint. SOLD PER MTR.   SIZE Base: into track compressed 9.3 mm actual size is 10.25 mm Height 18,00 mm hollow for softer...

 Can be glued on. Original has clips to push into door frame. Other applications also. fix to body with our 3M adhesive. SOLD PER MTR  of the coil    BASE size 12.6  total height 19.5mm   centre...

Holden FX-FJ - Boot Seal Join this end to end with Supa Glue for fitting to vehicle use our PRODUCT  613-011 ADHESIVE Sold as: Each

Holden FX-FJ - Front Door Seal, 2 required for a pair Fits All Body styles Ute P/van and SEDAN Sold as: Each

Holden FX-FJ - Rear Door Seal, 2 required for a pair Sold as: Each

Sold per mtr. of the roll. Produced in Australia for Old Era Service. Base size is 12.3mm height  11.5 mm Flap extends 3.0mm Fix to body with our 3M adhesive.

Hollow D sponge tube 16mm wide x 9mm Sold as: Meter

Hollow D sponge tube with single wisker 16mm wide x11mm Sold as: Meter

Hollow D sponge tube with twin wisker 20mm wide x15mm Sold as: Meter

Popular arrow head style glues to door car and trucks Sold as: Meter

Door seal for Austin A30's and other applications ,where you need a soft close on your door. Sold Per mtr. SIZE  Base 13.25 mm  Back 13.25 mm thin wall material. Closed cell sponge will not absorb water , made for...

Quad Sponge (firm NOT soft) 17 mm x 13mm Sold as: Meter

 Sold Per Mtr.  re use your finisher ends  Holden and Chevrolet..

 Sold per mtr. Size base 11.6mm total height 15mm. Use our 3M adhesive to glue this to your door. Also for end to end joins use our super glue. SEE 260-055 for LARGER Version.

 Door or gap filler does crush down to 10mm. With a base width of 11mm Uncrushed height 14mm  Glue on with our 3m adhesive.

Sponge seal Made In Australia. Sold per mtr. Fix to body work with our 3M adhesive. Size base 13 mm height 17.4 width back to front at top 18.5mm

SOLD PER MTR. Good general purpose item glue to body. Use or quality 3M glue shown in this section. SIZE    Base width 14mm Height tallest side 22mm  short leg 18mm

This glue is most suitable for Rubber to Rubber joining. AND OTHER THINGS YOU MAY BREAK!!! MAKE SURE YOU HAVE A CLEAN CUT (single straight cut) NOT JAGGED. IMPORTANT  GLUE ON  ONLY 1 SIDE THEN JOIN TOGETHER, HOLD...

Universal door and boot does suit Peugeot 203 1950-55 Sold as: Meter

SOLD PER MTR. Glue on with our 3M adhesive SIZES:  Base width 14mm  Total height  15mm Crush down to 8mm